Certified Regions and Geographies - xArray

Certified Reader ProductsCertified Gateway Products

The following table outlines the different regions and geographies where each Impinj gateway is certified. [Note 1]

  Approved Gateway Part Numbers
Region  R640 (xPortal)   R660 (xSpan)   R680 (xArray) 
Australia GX3 GX3 GX3
Brazil GX1 [Note 6] GX1 GX1
China N/A GX2 GX2
European Union EU1 EU1 (865-868 MHz)
EU2 (915-921 MHz) [Note 2]
EU1 (865-868 MHz)
EU2 (915-921 MHz) [Note 2]
Hong Kong GX1 GX1 N/A
India [Note 3] N/A EU1 EU1
Japan N/A JP2 JP2
Malaysia GX1 N/A N/A
New Zealand GX1 GX1 N/A
Philippines N/A N/A N/A
Saudi Arabia N/A EU1 EU1
Singapore [Note 4] N/A GX1 GX1
South Africa GX2 GX2 GX2
South Korea GX2 GX2 [Note 7] GX2
Taiwan GX1 GX1 GX1
Thailand GX1 GX1 N/A
Uruguay N/A N/A N/A
Vietnam N/A N/A N/A

Note 1: Subject to change.  Certification means having a LLRP region identification number and a regulatory certificate where required.  Regulatory certification is voluntary in some countries. N/A indicates there is no certification for that device and therefore this product cannot be used in that region.

Note 2: Conforms with Article 3.1(b) of EN 301 489-3 v2.1.1 and Article 3.2 of EN 302 208 v3.3.0 Draft 2020-05. Visit this page for more details about the acceptance of this new standard by specific EU countries.

Note 3: Must be purchased from authorized India distributor.

Note 4: Users are required to obtain a license for each use case where the radiated power during operation is between 500mW and 2000mW. Contact the local regulatory authority to obtain a license.

Note 6: Impinj xPortal regulatory certificate for Brazil will expire on November 30, 2020 and will not be renewed. Please visit this Product Change Notice for more details.

Note 7: Download and install this upg file to enable the South Korea region on the xSpan.

To ensure regulatory compliance, professional installers / integrators must follow the transmit power setting instructions provided in the Installation and Operations Guide. Impinj recommends readers should be used with the antennas listed in Appendix A of the Installation and Operations Guide or with antenna(s) of the same type with equal or less gain. RFID Integrators should contact the regulatory agency in the country where equipment is to be used to determine if their RFID system requires any additional testing/certification.

Was this article helpful?
0 out of 0 found this helpful


  • Supported Regions table has been updated. We have added R120/R420/R680 support for Saudi Arabia.

    Comment actions Permalink
  • Supported Regions table has been updated. We have added R420/R660/R680 support for the European Union ETSI upper band (915-921 MHz).

    Comment actions Permalink

Article is closed for comments.